Turnigy fabrikator bed cools down when printing

[WILL_STEF]

Hi,
I have a turnigy fabrikator. Everything works but after about 5 mins of printing the bed cools down from 100C to 82C. My extruder can only print abs so I am in a bit of a tight spot. any way I could stop that or print abs at that bed temperature?

[curious aardvark]

umm, if your extruder can print abs then it can also print: pla, pet-g, any pla based filament and just about every other kind of filament out there.

Who told you it will only print abs ??
All the adverts I've just looked at state abs and pla.

[WILL_STEF]

I believe I have the Metal J-head V6 Hotend but when I try to print in pla it expands in the extruder and clogs. I have tried lower the temperature and adding a fan but it doesn't work.