Quote Originally Posted by Roxy View Post
Grab RCBugFix. You just turn on the #define BLTOUCH option and everything works....
Hi

Ok, here's what I did:

Grab RCBugFix, define the display (RepRap Discount Smart Graphical), upload the code to the Ramps.

Reset Ramps

There is no graphic on the display for the heated bed

Try to set bed heat ... no go (from serial, or from sub menus).

Try to run PID tune on the bed ... thermal runaway, glass bed shatters into many pieces. Why did I try that? Terminal stupidity is my only excuse

===

Repeat with everything in sight. I only get a bed heat graphic when the screen reads " UBL6 FT-2020 ready." All the other new branches have the issue with the bed heat on my machine.

I'll pound on it some more this evening. Firmware usually works best after you have a few beers and yell at it a lot ....


Bob