Subscribe to Our Newsletter Advertise
Close



Results 1 to 1 of 1
  1. 10-24-2016, 09:06 PM #1
    manboy
    manboy is offline
    Student
    Join Date
    Oct 2016
    Posts
    1

    Unhappy Extrusion starts too late and stops too soon - Anyone ever see something like this?

    This is occurring on a Makerfarm i3v 8" that has TI electronics and is running a modified version of Tonokip. Extruder has been calibrated. Prints are run through Cura. The extrusion motor will stop spinning early, any ideas on what's causing this?

    photo(5).jpg
    Last edited by manboy; 10-24-2016 at 09:21 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules