Hi New to this board and new to 3D printing although not to CNC

Although the new Makerbot Print is better than the descktop I still like the features of Simplify3D.
I have used the default setup for the Rep5Gen in 3.1 and tweeked it about alot (maybe too much).
Not getting the results I expect. So

Is anyone out there using the Makerbot Rep 5th gen with Simplify3d 3.1 and have better luck, can you export your profile to an *.fff file and post here.

Thanks, If I have more sucsess I will post mine, but stuck at the moment

Thanks ... JCS