Close



Results 1 to 2 of 2
  1. #1
    Engineer-in-Training
    Join Date
    Jan 2016
    Posts
    326

    PETG rough surface on bottom

    Two days ago, someone posted a message at http://3dprintboard.com/showthread.p...highlight=petg asking for help with Z-Offset in Cura. In that message there is a link to another website at https://www.xyzfabs.com/forums/topic...lack-filament/ I set up Simplify 3D following instructions on that website. After 3D-printing a test box, I tried to 3D-print sunroof for a model car that require supports and the bottom surface is still rough. How can I fix this problem?

  2. #2
    Engineer-in-Training
    Join Date
    Jan 2016
    Posts
    326
    Should I try different filament suitable for mechanical parts like gears?

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •