Selling my Duplicator i3 3D printer that's fully modded. Barely used, and prints beautifully. $375 for local pickup in Riverside, California.

- Upgraded the hotend with an all-metal upgrade so higher temp materials can be printed.
- Bearing mod was performed (replaced roller bearings with superior longer ones)
- Notched out the bearing block so the belt doesn't ride on it.
- Replaced the extruder gear with a superior one
- Replaced the fan with a superior one
- Added Z-braces for superior stability. Made the frame square and rock solid. This improved prints drastically.
- Chain relief
- Modded the Z limit switch so it can be fine tuned. Great for adding glass.
- Emergency stop was added
- Added thumbwheels to adjust the bed

A few other minor mods as well.