Anyone used Printbite surface ?

[curious aardvark]

Actually one of the things that's come out of this is the fact that I'm a lot more confident in both printing a lot of things at once and using the whole surface of the build plate.
Because even minute inperfections in your build surface will cause issues, I pretty much used to use either the centre of the plate or whatever part didn't have ripped, damaged or peeled tape/pva/pei.

With a big flat, smooth surface, I have none of those issues so can use the whole area secure in the knowlege that I won't need a hydraulic ram to remove anything and that a lot of small pieces will stick equally well no matter where they are.

So if you only or mainly use pla - I'd say you NEED a sheet of this stuff. Maybe not perfect - but at the moment - as far as pla goes - I can't think of anything that would improve it.

Some trolley tokens I just ran off.

29trolley tokens_800x600.jpg