Subscribe to Our Newsletter Advertise
Close



Page 3 of 3 FirstFirst 123
Results 21 to 22 of 22
  1. 03-05-2016, 02:06 PM #21
    Donziboy2
    Donziboy2 is offline
    Student
    Join Date
    Jan 2016
    Posts
    34
    Got my printing doing some test prints today. On my third print of the day using PLA(60C bed) im about 2 hours in and the SMD board is staying below 90F. I have not changed from the stock relay sw configuration yet but it seems I over engineered my torture tests at work.
    Reply With Quote Reply With Quote
  2. 03-06-2016, 06:36 AM #22
    Donziboy2
    Donziboy2 is offline
    Student
    Join Date
    Jan 2016
    Posts
    34
    Got PID control setup on the Heated Bed, the switching frequency is much lower then I had expected (only 7.633Hz). Other then some hot wires(need to increase # of wires from ATX supply to bed) everything is nice and cool.

    Reply With Quote Reply With Quote
Page 3 of 3 FirstFirst 123
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules