Subscribe to Our Newsletter Advertise
Close



Results 1 to 3 of 3
  1. 01-11-2016, 04:57 AM #1
    jeffmorris
    jeffmorris is offline
    Engineer-in-Training
    Join Date
    Jan 2016
    Posts
    326

    Tips and tricks on using BuildTak?

    I ordered some BuildTak after ripping the Kapton tape on my PowerSpec Ultra 3D printer while removing objects from the printer. Any tips and tricks on using BuildTak?
    Reply With Quote Reply With Quote
  2. 01-11-2016, 05:38 AM #2
    Davo
    Davo is offline
    Staff Engineer Davo's Avatar
    Join Date
    Nov 2013
    Location
    Atlanta, GA
    Posts
    1,084
    Follow Davo On Twitter Add Davo on Facebook Add Davo on Google+ Add Davo on Shapeways Add Davo on Thingiverse
    It grabs ABS very, very well. Be careful removing your work.
    Reply With Quote Reply With Quote
  3. 01-11-2016, 11:25 AM #3
    LuckyImperial
    LuckyImperial is offline
    Technologist LuckyImperial's Avatar
    Join Date
    May 2015
    Location
    Campbell, CA
    Posts
    162
    Davo is correct. Things will adhere to it incredibly well. Start your prints with an extremely low bed temperature just to feel it out at first. If you print ABS onto it at 100C you will likely ruin the print and the sheet trying to pry/scrape it off.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules