Results 11 to 12 of 12
-
01-03-2016, 09:17 AM #11
- Join Date
- Dec 2015
- Location
- Seattle
- Posts
- 38
This might be a good way to get a fan shroud printed (so I can again print a better shroud.) Thanks for the tip.
-
01-03-2016, 11:47 AM #12
- Join Date
- Dec 2015
- Location
- Seattle
- Posts
- 38
Alright, so heat is an issue. I intentionally spaced them semi-close to see if the shoulders that were closest would be problematic (They weren't.)
That being said, they weren't particularly great, and I had to press the corners down as suggested by EagleSeven, but it's definite progress.
20160103_093716.jpg20160103_093729.jpg20160103_093818.jpg20160103_093848.jpg
For those curious: this was printed with 10% infill, .27 layer height, with a single shell. Feed 30, travel 40, temp 190.
Extruder not feeding during print,...
Yesterday, 02:02 PM in Tips, Tricks and Tech Help