Builds that are really tough on your printer

[Sebastian Finke]

For clarity's sake:

The 'posts' on the OP's part are shafts (round) and beams (rectangular).

[Ward]

I will take this as a learning curve for me, I will try to be more carefull in my future replies to ensure the wording can have only one meaning; but with limited characters in a reply it can be a problem.

I nearly used the word 'posts' instead of 'replies' in the above, that would have made it even more confusing.

Good luck with your printout.

Paul,
I was referring to my "duncity"...not yours
Your reply was clear, not sure why I didn't understand it right off the bat. Can I use "getting old" as an excuse ????

[Ward]

One thing about this forum....most people are very helpful and down to Earth.
Thanks to everyone for your help

The members of this forum have helped me come a long way very quickly.

[iDig3Dprinting]

Paul,
I was referring to my "duncity"...not yours
Your reply was clear, not sure why I didn't understand it right off the bat. Can I use "getting old" as an excuse ????

We knew what you meant, we just loved the photo and your humility in admitting your error, that was all we referred to.