Technical Information Resources

[Ward]

Suppose someone wanted to really read the technical aspects of 3D printing rather than the basics...someone with too much time on their hands

For example, a full indepth discussion of infill, layer height and virtually all the parameters involved in 3D printing.

Is there a good place to go to read up on all those technical aspects and the effect they have on printing?

* * *

Added by CA:
Any post that is clearly there just to make up the poster's numbers and does not have any useful information will be deleted.

[Davo]

http://reprap.org/wiki/Print_Trouble...ictorial_Guide

http://support.3dverkstan.se/article...shooting-guide

https://www.simplify3d.com/support/p...oubleshooting/

https://all3dp.com/common-3d-printin...eir-solutions/

https://ultimaker.com/en/support/vis...shooting-guide

...

I'm sure your google-fu is adequate.

http://manual.slic3r.org is as good a place to start as any.

[Ward]

Look at this one....
http://softsolder.com/2013/03/14/g-c...d-master-list/