Results 1 to 6 of 6
Thread: Technical Information Resources
-
11-23-2015, 10:37 AM #1
Technical Information Resources
Suppose someone wanted to really read the technical aspects of 3D printing rather than the basics...someone with too much time on their hands
For example, a full indepth discussion of infill, layer height and virtually all the parameters involved in 3D printing.
Is there a good place to go to read up on all those technical aspects and the effect they have on printing?
* * *
Added by CA:
Any post that is clearly there just to make up the poster's numbers and does not have any useful information will be deleted.
Last edited by curious aardvark; 02-24-2020 at 03:25 PM.
-
11-23-2015, 10:43 AM #2
http://reprap.org/wiki/Print_Trouble...ictorial_Guide
http://support.3dverkstan.se/article...shooting-guide
https://www.simplify3d.com/support/p...oubleshooting/
https://all3dp.com/common-3d-printin...eir-solutions/
https://ultimaker.com/en/support/vis...shooting-guide
...
I'm sure your google-fu is adequate.
http://manual.slic3r.org is as good a place to start as any.
-
11-23-2015, 12:47 PM #3
Look at this one....
http://softsolder.com/2013/03/14/g-c...d-master-list/
-
05-05-2022, 06:21 AM #4
- Join Date
- May 2022
- Posts
- 2
Printing speed
I’m having issues with my first layer speed. I did set the speed lower in cura but for some reason when come to certain areas it will speed up very quick not laying filament properly ending in failed first layer… ideas?
-
05-05-2022, 11:48 AM #5
- Join Date
- May 2022
- Posts
- 2
-
05-05-2022, 01:56 PM #6
- Join Date
- May 2020
- Posts
- 689
I am not as knowledgeable about Cura or any slcicer as I would like to be so I can only offer any information that occurrs to me.
At a guess it will be a setting somewhere in the numerous speed settings, could even be the travel speed, typically in my slicer it's set at 100mm/sec.
I think it is really a matter of experimenting with various settings, slower is very often better than risking a ruined print.
layers start moving
12-01-2024, 07:41 PM in Tips, Tricks and Tech Help