Subscribe to Our Newsletter Advertise
Close



Results 1 to 3 of 3
  1. 11-16-2015, 04:22 PM #1
    ThomasB96
    ThomasB96 is offline
    Student
    Join Date
    Nov 2015
    Posts
    3

    Unhappy Top and bottom layers out of place with Freaks3D printer.

    Recently got a Freaks3D printer, first printer I own. Had many problems building and now printing. Printer problems are endless. Not sure why this happened to this print, it's just a 15mm test cube. Also it was oozing at the corners of each layer creating a blob.
    Attached Images Attached Images
    Reply With Quote Reply With Quote
  2. 11-16-2015, 04:57 PM #2
    Roxy
    Roxy is offline
    Super Moderator Roxy's Avatar
    Join Date
    Apr 2014
    Location
    Lone Star State
    Posts
    2,182
    It looks like your printer slips 10mm on the one axis every now and then. Did the nozzle dig in on the layers it had a problem doing?
    Reply With Quote Reply With Quote
  3. 11-19-2015, 12:35 PM #3
    ThomasB96
    ThomasB96 is offline
    Student
    Join Date
    Nov 2015
    Posts
    3
    Tested the belt that move the bed and it isn't as taught as it should be. How do I make it taughter, I tried pulling the ends of it but nothing. The nozzle doesn't dig in only blobs at the corners
    Last edited by ThomasB96; 11-19-2015 at 10:26 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules