3D Printing Podcast!

[kkuntz16]

Hello All,

For a while now I have been scanning the threads looking for the most asked about topics. The reason I have been doing this is because I would like to create a podcast or webinar where the most popular 3D printing questions are asked and answered . My question to all of you is: What topics would you want discussed in these podcasts ?

These topics could range anywhere from beginner to expert or even 3D scanning to the best 3D software.

Let me know what you think.

[EagleSeven]

My most often asked Question is:

'Where can I Get the Free Stuff' ?? LOL

[curious aardvark]

These topics could range anywhere from beginner to expert or even 3D scanning to the best 3D software.

that works for me :-)

[LambdaFF]

A video that would answer the typical newbie questions on this forum so we could direct them to your vid instead : explain bowden / direct drive ; explain core xy; show what is a delta ; how to detect and correct not tight belts ; advantage of Z probe to perform a G29 ; a tuto on various extruder gens/heatbed/closed frame and the relation to usable material ; heatcreep ; filament material, bed and adherence ; testing temps on a new filament.

for slightly more experienced newbies :
demo on bicolor and how to set it up ( with a dual extruder and without)

But this is just to avoid typing the same stuff over and over. What would actually interest me or what I could contribute to is :
Demo of tolerances to apply on fittings.
Demo on advanced post processing methods and cheap kits (sandblasting ?, electroforming ?)