Results 11 to 13 of 13
Thread: Raft settings?
-
10-12-2015, 03:08 AM #11
Your need for rafts seems prompted by the use of ABS (significant warp ratio material). Have you considered moving to PET ? If yes, what repelled you ?
-
10-12-2015, 08:19 AM #12
- Join Date
- Jan 2015
- Posts
- 445
raft is TOOOOOOO sticky... raft sticks to bed just fine. sticks to part too much.
So i went all the way up to .5mm separation and it was a little easier to take off. not EASY per sae.
-
10-12-2015, 10:13 AM #13
- Join Date
- Jan 2015
- Posts
- 445
I do use some pet... I think what i like about abs is its easier to print. PETG is pretty hard to lock in, and if its not JUST RIGHT than the part doesnt work.
QIDI Slicer "Plater" is...
04-12-2024, 02:21 AM in QiDi 3D Printer Forum