Makergeeks 230mm Delta. PSU hook up?

[Fantastic Brass Ninja]

If a mod see this, feel free to delete.

Thanks much.

Ti

[Fantastic Brass Ninja]

Post edit.

[curious aardvark]

so you got it working then ?

[Fantastic Brass Ninja]

so you got it working then ?

HA! Yes, I did somewhat. I have gotten to where I can send commands from Repetier, but there are still some things not 100%. Endstops, all axis only move up, ect.

I might like to start another thread, but after how stellar this one was, I'm not sure I'd need too.

[LuckyImperial]

HA! Yes, I did somewhat. I have gotten to where I can send commands from Repetier, but there are still some things not 100%. Endstops, all axis only move up, ect.

I might like to start another thread, but after how stellar this one was, I'm not sure I'd need too.

That's a good looking Kossel. I recommenced not using small gauge wire too or from your PSU. An old, 16awg PSU cable can be sacrificed for much higher quality power wire:

http://www.monoprice.com/Product?p_i...sUMaAnu18P8HAQ

Don't use that crappy 24awg endstop wire for any power wiring. I've seen phoenix connectors burn up because of improper wiring.

[Fantastic Brass Ninja]

Thanks for the suggestion, Lucky! Duly noted.