Bed warped suddenly?

[EagleSeven]

I cable tied to two rods on the left and right that run front to back as these have a tiny bit of slack.

??? Are you talking about the drive-Belts ?
There should be small springs slipped over the Belts,
that keep them fairly tight on pulleys.

[maxed280]

No no lol, the Y axis i belive. the two highest rods.

So after taking the extrudes apart ive found the problem.

I was thinking the PLA was not sticking to the bed due to it not being level etc but turns out the stepper motor wheel had come loose so wasn't pushing the PLA out of the nozzle!!!!

So now im getting prints again and trying to get the quality back up

[EagleSeven]

Great !
We knew You could Do it !

[maxed280]

Lol thanks for your help,