Configuring home locations.

[CBPrints]

Hey guys,

I managed to get the firmware flashed and it connected to my laptop.

However I am currently using Repetier and my X directions arent functioning properly, whether I move the X left or right it goes to the right always except a rare occasion after I restart it.

Also, My Y home moves my bed all the way to the back, I tried switching the home from min to max, then 0 and it stays at the very back when homed.

Thanks,
CB

[LambdaFF]

Check the following :
1/ your endstops are connected and working.
2/ invert the motor if you can't solve it by soft.