Close



Results 1 to 2 of 2
  1. #1
    Student CBPrints's Avatar
    Join Date
    Jun 2015
    Location
    Canada
    Posts
    10
    Add CBPrints on Thingiverse

    Configuring home locations.

    Hey guys,

    I managed to get the firmware flashed and it connected to my laptop.

    However I am currently using Repetier and my X directions arent functioning properly, whether I move the X left or right it goes to the right always except a rare occasion after I restart it.

    Also, My Y home moves my bed all the way to the back, I tried switching the home from min to max, then 0 and it stays at the very back when homed.

    Thanks,
    CB

  2. #2
    Staff Engineer LambdaFF's Avatar
    Join Date
    Jan 2014
    Location
    France, Aix en Provence
    Posts
    1,140
    Check the following :
    1/ your endstops are connected and working.
    2/ invert the motor if you can't solve it by soft.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •