Results 1 to 2 of 2
-
08-01-2015, 12:40 PM #1Student
- Join Date
- May 2015
- Posts
- 49
Where can I buy a RAMPS power plug?
The power plug to my RAMPS board started to come loose during a long print, resulting in a poor connection, heat and melting around one of the pins of the dual 12V connector. The socket on the board itself is OK. Anyone know where I can buy just the 4 pin (actually two 2-pin) connector by itself? Thanks.
-
08-01-2015, 01:21 PM #2Staff Engineer
- Join Date
- May 2014
- Location
- Highlands Ranch, Colorado USA
- Posts
- 1,437
The http://www.reprap.org/wiki/RAMPS_1.4#Bill_of_Materials shows the 4-pin version of the mating connector as WM7953. The Wiki has a link to the part from Digikey; that listing mentions it is Molex part number 39530-0004. 39530-0002 would be a two-contact version, but I can't speak to whether they are gangable or not for installation of two of them into the 4-pin board connector.
Last edited by printbus; 08-01-2015 at 06:15 PM.
Reply With Quote
Print not sticking to base plate?
Yesterday, 01:26 PM in General 3D Printing Discussion