Stair-step print Problem, of Large objects, using Makerbot-3.7

[EagleSeven]

Try using 3.6 Makerware.

Use an higher infill, something like 50%+.

Thanks for the reply,
Do you work for CTC , or just using their logo and name ?

I will try to find where to download 3.6 and if I can get it to install over 3.7, to replace it.
(We had problem trying to replace 3.7 with 2.4, would not install)
(I'm Not going to change version on the hard-drive that we now have 2.4 on,
but 3.7 is still on the other hard-drive)

I've never had Infill above 15%, but will give it a try next time we have that problem.
It seems that would require more Memory , not less, which seems to be the problem with 3.7 ?

Addition: I can Not find a website where I can download Makerbot-3.6
It defaults to latest version which is 3.7
Where can I get 3.6 ???

Note: if you are employed at CTC ,you should know that version 3.6 can not be downloaded from Makerbot website ?
CTC_logo.JPG

[EagleSeven]

I wanted to do follow-up report that our printer is working well using 2.4 version of Makerware ,
with none of the problem seen with version 3.7

Ol' 2.4 and I have become 'Good Friends' ! LOL