Results 1 to 2 of 2
Thread: Need left hand lower 2/3 forearm
-
03-29-2015, 11:27 AM #1
- Join Date
- Mar 2015
- Posts
- 1
-
07-25-2015, 04:59 PM #2
- Join Date
- Jun 2015
- Posts
- 4
Hi,
There are actually 3 designs that might look like a clue: EXIII, OPEN HAND and UNLIMITED TOMORROW. but to adapt them is a hard work, not just press 'print' : /
These use Myo electric sensors ( EMG ). The Exiii is fast but weak.
The e-nable ones are meant for people with the carp(half hand)
If you go further in this research, start by the general idea that the prosthetic hand would go straight from the shoulder without an elbow articulation, the stump is too short to give any control.
Tell me if you wanna speak about itLast edited by Melodicpinpon; 07-25-2015 at 05:06 PM.
Need Cura Profile for Tronxy Moore...
12-05-2024, 05:55 AM in 3D Printing Slicer Discussion