Results 1 to 4 of 4
Thread: Flashforge vs Ultimaker 2
-
03-17-2015, 03:30 AM #1
- Join Date
- Mar 2015
- Posts
- 1
Flashforge vs Ultimaker 2
Hi guys,
I've been doing some research on a potential printer for small model parts. This means that I'll be aiming for detail/quality over print speed and print area. I was hoping to find a printer with the most detail ~$1500, and I've been getting the feeling that it's going to be either the flashforge creator pro or the ultimaker 2 go. Does anyone have any experience between the two. I understand the Ultimaker 2 Go isn't out yet, but I figure it'd be pretty similar to the ultimaker 2 sans heated bed (I'm also open to suggestions if anyone has other options).
Thanks in advance.
-
03-17-2015, 03:55 AM #2
Hard to compare a printer that is not out yet? We have a Replicator and an Ultimaker 2. The Ultimaker 2 consistently prints better than the Replicator and breaks down less. That is not to say the Replicator is not a good printer, it is just more problematic.
-
03-19-2015, 02:43 AM #3
We offer an upgraded Replicator 2 that will print .50mm
Whatever you get, make sure you can have it fixed!
-
03-19-2015, 05:10 AM #4
printrbot metal. you just don't hear any negatives about them.
Extruder not feeding during print,...
Yesterday, 01:59 AM in Tips, Tricks and Tech Help