Close



Results 1 to 4 of 4
  1. #1
    Kudo3D Representative
    Join Date
    May 2014
    Location
    San Francisco, CA
    Posts
    29

    Kudo3D Introduces 2nd Generation PSP Container

    We recently launched our second-generation passive self-peeling (PSP) resin container. Our testing of the container has yielded excellent results. We have completed 52 prints in a row! We are observing higher resolution and better surface smoothness. We only used about 200g of castable resin to complete all of these prints.


    Printing speeds have increased as well! At 37 microns XY and 35 microns Z, we are printing around 40% faster at 1 inch per hour. Printing at lower resolutions such as 50 microns and 100 microns XY is faster as well, but the increase is not as high as 40%. All of the prints in the picture above took between 1 to 2 hours to print. The rings took only 1 hour!

    Attached Images Attached Images
    Last edited by Roberta3D; 03-04-2015 at 07:38 PM.

  2. #2
    Staff Engineer
    Join Date
    Jun 2014
    Posts
    886
    A bit of confusion... Second generation resin, as stated in the post, or second generation resin container?

    I was not able to find the purchase link for this revolutionary new product!

  3. #3
    Kudo3D Representative
    Join Date
    May 2014
    Location
    San Francisco, CA
    Posts
    29
    Hi fred_dot_u,

    Thank you for catching that typo! It is a second generation PSP container and it is available through our website:

    http://www.kudo3d.com/product/psp-resin-container/

    It has replaced our original PSP container and our prices have remained the same.

    Take care!

    Roberta

  4. #4
    Staff Engineer
    Join Date
    Jun 2014
    Posts
    886
    Can a first generation container (unused) be exchanged for credit or otherwise upgraded to reduce upgrade expense?

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •