Results 1 to 4 of 4
Thread: HELP please !
-
02-20-2015, 12:04 PM #1
- Join Date
- Feb 2015
- Posts
- 6
HELP please !
Hello everyone.. i start printing this few days and suddenly the filament melt inside the extruder.. how can i fix this problem please... the picture in Attachments
-
02-20-2015, 04:24 PM #2
Clean it out and try again. Could have been a one off flaw in the filament. If you can replicate the problem, then you have a problem.
-
02-20-2015, 11:21 PM #3
- Join Date
- Aug 2014
- Location
- Montreal, Quebec
- Posts
- 576
I'll also add to add a small blower fan to cool off the peek tube and the extruder structure. Just to prevent jamming or heat transfer going up that screw your prints.
-
02-21-2015, 03:50 AM #4
From what I see you've got an all metal structure with about 1cm between the heat block and the extruder... Correct ? If so, Richardphat has it right and a good amount of cooling is necessary at all times.
Extruder not feeding during print,...
Yesterday, 01:59 AM in Tips, Tricks and Tech Help