Close



Results 1 to 5 of 5
  1. #1

    CTC 3D Dual Extruder and Simplify3d Software

    My 3d printer prints fine using Makerbot. whenever i try to print using simplify3d, the ABS filament comes out slow and begins to clog up. Anyone using Simplify3d with a CTC3d printer? I think my FFF settings need to be tweaked but not sure what to do.

  2. #2
    Staff Engineer LambdaFF's Avatar
    Join Date
    Jan 2014
    Location
    France, Aix en Provence
    Posts
    1,139
    I'm using Simplify3D too. I tweaked the values by experimentation. What I suggest is you go to your process page and put here screens of all the tabs and we can discuss that.

  3. #3
    Here are the remaining settings.

    Attached Images Attached Images

  4. #4
    I had to delete my original post because i couldnt edit it. "The message you have entered is too short. Please lengthen your message to at least 10 characters."

    Attached Images Attached Images

  5. #5
    Staff Engineer LambdaFF's Avatar
    Join Date
    Jan 2014
    Location
    France, Aix en Provence
    Posts
    1,139
    Please :
    1/ try to enlarge a bit
    2/ I think the most important would be to display your extruder temp tab as well as be temp tab and finally the tab with all the speeds.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •