Close



Dig deeper, search our News website




Search:

Type: Posts; User: Dant3

Search: Search took 0.00 seconds.

  1. Thread: Ender3 Problem

    by Dant3
    Replies
    1
    Views
    1,741

    Start with printing a calibration cube. It...

    Start with printing a calibration cube.
    It prints ok?
    Also what temps are you using?
    I guess you have PLA.
  2. For the record, I sold the printer and got an...

    For the record,
    I sold the printer and got an Ender 3 V2.
    Works great so far with my old filaments.
    So I guess it was printer related issue.
  3. Replies
    3
    Views
    2,552

    Is it just 1 layer? If yes,then you need to...

    Is it just 1 layer?
    If yes,then you need to increase a bit the distance of the nozzle with the bed.
    Also experiment a bit with the temps of the filament.
    There is a setting about how much the...
  4. Well here is a vid. The motherboard was on a...

    Well here is a vid.
    The motherboard was on a chair with connected just the necessary.Heater,thermistor and the extruder.Nothing else.
    You can clearly listen to the extruder clicking.
    Note that the...
  5. I goy a box and placed all my filaments inside...

    I goy a box and placed all my filaments inside alongside with all the silicone tabs that are given with the filaments,electronics etc.


    I tried that and nothing changed.


    I got a whole new...
  6. Yeah,I will upload a video. For now I'm doing...

    Yeah,I will upload a video.
    For now I'm doing some tries with increased temperature.
    Looks like 210 C and up ,PLA somehow manages to print.Anything lower than 205 and within a minute,the extruder...
  7. Dismantled the printer ,at least the electronics...

    Dismantled the printer ,at least the electronics and reconnected everything.
    Also disassembled the hotend once again.
    I swapped the stepper from E0 to E1.Same happens.
    Also swapped the hotend from...
  8. Well mine definetely has no sockets. The...

    Well mine definetely has no sockets.
    The motherboard is a MKS 1.4
    Well I think I can try to connect the extruder to the E1 plug.
    It supports dual extrusion so I guess it should be able to do that.
  9. I guess I have to replace the motherboard if the...

    I guess I have to replace the motherboard if the motor driver chip has gone bad?I have a soldering iron if it is replaceable and I can replace it.
    The PTFE liner has been replaced.


    I have...
  10. Tried another Slicer,same happens. I m gonna go...

    Tried another Slicer,same happens.
    I m gonna go ahead and dismantle the whole printer,at least the electronics to make a visual inspection.
    Next I m gonna replace the motherboard.
    If these dont...
  11. Nozzle constantly clogs,can't seem to find a solution

    Good evening,
    For almost 3 years I have a stock Tevo Tarantula,except for some minor improvements.

    Some months ago while printing a 4 hour PETG print my nozzle clogged for the first time ever.
    I...
Results 1 to 11 of 11