Close



Dig deeper, search our News website




Search:

Type: Posts; User: NeilR

Search: Search took 0.00 seconds.

  1. Replies
    11
    Views
    33,011

    Open Letter to Rylan

    Rylan I don't speak for anyone but myself and with that being said here are a few quick thoughts from me.

    First try not to let the angry people get you down, yes they have a right to be angry...
  2. Replies
    52
    Views
    179,085

    Sticky: Here is a fairly bad sketch of what I was going...

    Here is a fairly bad sketch of what I was going to set up for my drip system to minimize the chance of disturbing the resin layer. Using a 1" pvc pipe to contain the drips, this would also work for...
  3. Replies
    52
    Views
    179,085

    Sticky: I was thinking that the high viscosity would...

    I was thinking that the high viscosity would cause the surface tension of the resin to prevent it from covering the surface, by "grabbing" the edges of the print and not flowing over the top.

    If...
  4. Replies
    48
    Views
    161,787

    Sticky: I am sure they are hesitant to respond to this...

    I am sure they are hesitant to respond to this because no matter how many qualifications, or statements of "estimate" they give there will be some who will get mad at them if they are off or have to...
  5. Replies
    4
    Views
    6,725

    google Montana jars, they look like they might be...

    google Montana jars, they look like they might be a good starting place. found one at Bed Bath and Beyond for $15 about 10" high and a 8" diameter.
  6. Replies
    13
    Views
    20,470

    I am still liking the small wire mesh but in...

    I am still liking the small wire mesh but in steel because after you remove the model it would be easy to recover the mesh by removing the printed "base". Also I would be able to make it into an...
  7. Replies
    13
    Views
    20,470

    I initially was thinking the same thing but after...

    I initially was thinking the same thing but after a little more thought I decided that the wire was a good choice, as it can be easily cleaned and reused. And I am sure that after we gain some...
  8. Replies
    1
    Views
    5,079

    Ideal Peach Height

    So is there a best distance from the print surface to the Peachy printer laser?
  9. Thread: Ideas

    by NeilR
    Replies
    16
    Views
    25,162

    Yes printing some would be my choice and was...

    Yes printing some would be my choice and was looking but with a ridged resin this style would not work so I am looking at some other designs. Also I was throwing it out there more for the customers...
  10. Thread: Ideas

    by NeilR
    Replies
    16
    Views
    25,162

    rather than use those rings I was looking at...

    rather than use those rings I was looking at these:
    http://www.rebelbrewer.com/wp-content/uploads/2013/03/whiteclip__38785.jpg

    found them here:...
  11. Thread: Ideas

    by NeilR
    Replies
    16
    Views
    25,162

    I am planning on starting with the basic setup...

    I am planning on starting with the basic setup when I get my Peachy, so I can be sure I have it all figured out. Then I was thinking of using a larger container and getting the drip settings working...
Results 1 to 11 of 11