Close



Dig deeper, search our News website




Search:

Type: Posts; User: redbeardprint

Search: Search took 0.00 seconds.

  1. Replies
    2
    Views
    5,987

    Hey. I had terrible issues lately with my...

    Hey.
    I had terrible issues lately with my Z-Offset and my BLTouch. I spent almost 4 full days and nights adjusting and trying to get it right. I'd get it right for one print. Then the next print the...
  2. Ender 3 first layer problems all of a sudden

    Hi all.

    I had previously been able to print really good prints (I thought so at least) but more importantly, a really good first layer. Nothing has really changed - but all of a sudden my first...
  3. Replies
    0
    Views
    1,712

    MKS Gen L with TMC2208 drivers

    I've installed a MKS GEN L on my Ender 3.
    I have two versions of the TMC2208 drivers. I have v1.0 with 2 pads and v1.2 with 3 pads.
    I have followed Michael @ TeachingTech's steps as per this...
  4. Replies
    6
    Views
    4,881

    Pics 6, 7 & 8 Thanks :) 12857 12858 12859

    Pics 6, 7 & 8

    Thanks :)

    12857
    12858
    12859
  5. Replies
    6
    Views
    4,881

    Ender 3 Benchy test with PET-G

    Hi all,
    I have an Ender 3 and I think I have my settings dialed in, but have some issues I don't know how to fix.
    E-Steps have been calibrated.
    Speed 50mm/s
    Temp 240C and 70C
    Retraction 6mm and...
  6. Replies
    3
    Views
    3,697

    Thanks for that. Yeah it's so strange. When I...

    Thanks for that.
    Yeah it's so strange. When I run the GCODE in the slicer (Cura 4.0.0) and play through each layer it looks like it prints as per normal during those layers. There's no difference...
  7. Replies
    3
    Views
    3,697

    Is this a typical E-STEP issue?

    Hi all,
    Ender 3.
    Printing a storage tray from Thingiverse thing:2957317

    0.4mm nozzle
    0.12mm layer height
    20mm infill
    200C print temp
    60C bed temp
    50mm print speed
  8. Did you buy it new? They have a 12 month warranty.

    Did you buy it new? They have a 12 month warranty.
  9. Heat up the hotend and as it is heating up, keep...

    Heat up the hotend and as it is heating up, keep pulling on the PTFE tube with the fitting unscrewed as per your pic. The clog will come out.

    Not sure about your extruder. How old is the printer?...
  10. Replies
    0
    Views
    2,253

    Ender 3 calibration issues

    Hi all.

    New to 3D printing and while I have watched countless videos on the tubes of you, I'm struggling with getting my Creality Ender 3 dialed in.

    Mods that are more than just cosmetic are:...
Results 1 to 10 of 10