Where did the second picture I posted go? That was the one hat showed the problem. I know I posted it because I checked afterwards. Weird.
Type: Posts; User: galaxybeing
Where did the second picture I posted go? That was the one hat showed the problem. I know I posted it because I checked afterwards. Weird.
I bought this printer new about 9 months ago or so and have made q number of nice things on it. But I've always thought it sounded like the tip was scrubbing the print as it zig-zags back and forth...
I have an original Ender 3 and a Neptune 4 Max. Most of what I've done is PLA, with some small amount of ABS, which is just awful IMO. I'm told many of my warping and layer separation problems are...
Thank you. My next question is, if PLA prints at 210 and PETG at 235, off-hand that sounds like not that much more protection from a part still warping locked in the car in the sun on a July day....
I've been designing in Freecad and printing a lot of nice and useful things for about 3 years now. Mostly in PLA,and some ABS. But I avoid ABS unless I absolutely must have a part that can be taken...
My Neptune 4 Max has been pretty nice in the 6 months I've had i (new). But there's a big problem, which is depicted in the attached photos of a film developing tank I drew up.. Photo 1 shows the...
Well what do you recommend? ABS? H--no. I can't get that stuff to half stick to the bed. By the time the item is finished, it's warped, if it didn't come loose and get knocked over by the head...
I have a Neptune 4 Max, but this question could just as well pertain to my Ender 3, as I believe it's more of a slicer setting I don't know of, or may not even exist. I'm posting a JPEG of a speaker...