Close



Dig deeper, search our News website




Search:

Type: Posts; User: kcoughenour

Search: Search took 0.00 seconds.

  1. Replies
    6
    Views
    1,445

    OK, So I figured that I should update this post...

    OK, So I figured that I should update this post so I dont feel like I put some bad information out there. I was completely wrong about the brand of filament being a factor here. I finally stumbled...
  2. Replies
    6
    Views
    1,445

    Well, the best I could tell, it was coming back...

    Well, the best I could tell, it was coming back to the correct location. So as I was about to give up, I had a Eureka moment and decided to run the print again, still with the pause, but this time I...
  3. Replies
    6
    Views
    1,445

    OK, So I added another M code right after the...

    OK, So I added another M code right after the filament change to heat the filament to its maximum range which is 220 before resuming the print. I started the print at 200, which is the minimum. I...
  4. Replies
    6
    Views
    1,445

    issues after filament change

    Hi,I have a Creality Ender-3 Pro and am using a PLA+ filament. I edited my firmware to enable print pausing via the M600 command inserted into my gcode so that I can change filament colors at certain...
Results 1 to 4 of 4