Close



Dig deeper, search our News website




Search:

Type: Posts; User: Mike70515

Search: Search took 0.00 seconds.

  1. Replies
    0
    Views
    2,799

    CreatBot Firmware

    Has anyone been able to alter any settings in a CreatBot's firmware? I am new to this and don't even know what type of Firmware it actually uses (supposedly a modified version of Marlin) or how to...
  2. Replies
    4
    Views
    11,084

    3D Cad Software

    Could anyone recommend a decent 3D CAD Software that is free and similar to SolidWorks or Inventor?
  3. Replies
    10
    Views
    8,208

    From looking around in forums it seems to be a...

    From looking around in forums it seems to be a modified version of Marlin.
  4. Replies
    10
    Views
    8,208

    Do you know if any of the common Firmwares would...

    Do you know if any of the common Firmwares would work for the CreatBot? Or does it have to be a specific one?
  5. Replies
    10
    Views
    8,208

    Its only a millimeter smaller in diameter....

    Its only a millimeter smaller in diameter. However, the hole is right on the edge. I'm going to see about getting a new block machined.
  6. Replies
    10
    Views
    8,208

    Prometheus is currently out of thermistors. I had...

    Prometheus is currently out of thermistors. I had to order everything separately instead of a full hotend package. However, even if I had their thermistor, I don't know how to load a resistance table...
  7. Replies
    10
    Views
    8,208

    Are Thermistors interchangeable?

    I'm upgrading my old hotend to a Prometheus V2 but the new heat block doesn't provide a big enough hole for the original thermistor cartridge. If I were to order one that would fit the heat block,...
  8. Replies
    2
    Views
    2,207

    The hole for the thermistor it right by the edge...

    The hole for the thermistor it right by the edge of the block so I'm not sure I would have enough meat to bore it out.
  9. Replies
    2
    Views
    2,207

    CreatBot DX3 Mod

    I am attempting to switch out an old PEEK designed hotend with a Prometheus V2. My issue is the new heat block provides a 3mm hole for a cartridge thermistor but the CreatBot’s thermistor has a 4mm...
Results 1 to 9 of 10