Close



Dig deeper, search our News website




Search:

Type: Posts; User: casparlee

Search: Search took 0.00 seconds.

  1. Replies
    7
    Views
    7,815

    In most 3D printers (especially affordable home...

    In most 3D printers (especially affordable home FDM printer) beside the temperature of the nozzle and the heat-bed nothing is measured at all.
    Not even the position of the print-head relative to...
  2. Replies
    4
    Views
    3,169

    A jerk is basically the slew-rate of...

    A jerk is basically the slew-rate of acceleration, so a very easy way to get the jerk value is by mounting an appropriate MEMS accelerometers chip to the print-head (and or print-bed, depending on...
  3. Replies
    13
    Views
    10,754

    So most 3D printers do not have the means to...

    So most 3D printers do not have the means to measure ?jerk?. What they can do though is control it. That is, the jerks can be set (or rather limited) to some pre-chosen value (the best one is usually...
  4. Replies
    4
    Views
    5,076

    That said there are some experimental 3D printer...

    That said there are some experimental 3D printer setups where measurement (and possibly closed loop controls) is involved. (E.g. in SCARA robots, both serial or parallel mechanic designs. There it...
Results 1 to 4 of 4