Close
Flash Forge Guider



Dig deeper, search our News website




Search:

Type: Posts; User: BrokeIn3D

Search: Search took 0.00 seconds.

  1. And takes about a month to ship.

    And takes about a month to ship.
  2. I'm done modding my E3D V5 into a V6. Found a...

    I'm done modding my E3D V5 into a V6. Found a picture of a V6 heat break cut apart and based my heatbreak on it. I took a M8 bolt and cut off the head, then bored a 2mm hole through it. After that i...
  3. Mine is a direct drive, but no the filament does...

    Mine is a direct drive, but no the filament does not flatten under pressure.I did a quick burn test to compare the two and the Easy PLA caught fire very quickly and dripped like molten wax it was...
  4. It IS blowing, what i'm trying to say it that it...

    It IS blowing, what i'm trying to say it that it moves a ton of air, no way could there be insufficient cooling.As for the temps, 230 = one layer and jammed, 220 = one layer and jammed, 210 = jam,...
  5. Replies
    7
    Views
    633

    i should be in the clear now i think

    i should be in the clear now i think
  6. Replies
    7
    Views
    633

    Well a back arrow and a resubmission didn't seem...

    Well a back arrow and a resubmission didn't seem to help me so i might as well try to post here.
  7. Heat creep or bad filament? (E3D V5 / fiberlogy Easy PLA)

    I had a 10m roll of chinese green PLA that i bought from eBay and it worked very well, up to the point where i ran out of it.
    So i ordered a 0.85kg spool of fiberlogy's Easy PLA Graphite (as in...
Results 1 to 7 of 8