Close



Dig deeper, search our News website




Search:

Type: Posts; User: Suggy

Search: Search took 0.00 seconds.

  1. Thread: HBP Upgrade

    by Suggy
    Replies
    0
    Views
    2,072

    HBP Upgrade

    Hi all, I have made myself a new HBP to replace the one on my CTC printer
    New HBP as 4 wires coming out of the mat (130watt) 2 are for power +,-
    and 2 for the Thermistor (Item is this...
  2. Replies
    0
    Views
    1,961

    Heated bed not getting to correct tem

    Is there a way of testing the bed to see if its ok? and test the wires to the bed?
  3. Replies
    2
    Views
    2,705

    Hi Is it possible to change the setting? I...

    Hi
    Is it possible to change the setting? I cannot find any settings from the front panel
  4. Replies
    2
    Views
    2,705

    Bed Bottoming out

    looking for some help
    when starting a print the bed goes all the way to the bottom and stops when it hits the bottom of the housing which tilts the bed to one side. Are there any setting which I...
  5. Thread: Adding LED's

    by Suggy
    Replies
    2
    Views
    3,471

    Adding LED's

    I have a CTC 3D printer which I believe as a mighty board mb. There is a "RGB-LED 24v only" connection point on the mb which as nothing connected to it. F/w is sailfish v7.7.
    If I connect some led's...
  6. Replies
    3
    Views
    2,808

    Manual for sailfish says Acceleration is on by...

    Manual for sailfish says Acceleration is on by default.
    Was not the case so I just turned it on and all is fine now
  7. Replies
    3
    Views
    2,808

    Sorted it.

    Sorted it.
  8. Replies
    3
    Views
    2,808

    Prints sloping off

    Hi all, new to 3D printing. I have a new CTC printer that worked fine for a week then I desided to upgrade the F/M to sailfish v 7.7. This was not done by myself. I had a guy do it for me.
    Having a...
Results 1 to 8 of 8