Close



Dig deeper, search our News website




Search:

Type: Posts; User: juannadie

Search: Search took 0.00 seconds.

  1. Replies
    17
    Views
    74,839

    The Mark One requires a minimum solid area of 1...

    The Mark One requires a minimum solid area of 1 square inch to place fiber. The area has to be continous (in most cases holes are not allowed to place fiber). Note as well the fiber is a continous...
  2. Replies
    17
    Views
    74,839

    It is the second time my Mark One printer sudenly...

    It is the second time my Mark One printer sudenly stops with a 'Pinter Disabled' error message on the screen. It is frustating that the printer stops at 75% after half day pinting. Hope this will be...
  3. Replies
    17
    Views
    74,839

    I have the same issue. Tried to print more...

    I have the same issue. Tried to print more complex parts and was not able to add fiber layers, quite dissapointing. Still a nice printer but at this point very very limited in pinting options and...
  4. Replies
    17
    Views
    74,839

    Same problem I have with the reinforcing layers....

    Same problem I have with the reinforcing layers. Flat parts work well but I tried a couple of relativelly simple 3D parts and it didn't work. I assuming this is a software limitation and should be...
  5. Replies
    17
    Views
    74,839

    Hi, I am a new owner/user of the Mark One 3D...

    Hi,
    I am a new owner/user of the Mark One 3D Printer, one of those rare guys.
    It is pretty cool in fact. However as I start using it have issues adjusting the right printing settings. Will post on...
Results 1 to 5 of 5