Close



Dig deeper, search our News website




Search:

Type: Posts; User: mcinsand

Search: Search took 0.00 seconds.

  1. Replies
    9
    Views
    23,268

    Been enjoying the printer and slic3r... and then...

    Been enjoying the printer and slic3r... and then went beyond a small model. To configure for a Pegasus 10, just drop to 230 mm or so from the settings that Seattle_Phil had? I'm trying to get a...
  2. Replies
    4
    Views
    13,186

    Y axis problem now solved after putting a...

    Y axis problem now solved after putting a heatsink onto the Y axis driver chip. Y was slipping when test cube got to walls, and now is steady. Colin recommends avoiding heatsinks, and I can see...
  3. Replies
    4
    Views
    13,186

    Problem solved, sort of. I changed out the...

    Problem solved, sort of. I changed out the stepper driver board, and now the Z-axis is moving well. However, somewhere in the process, my y axis has started missing steps. I'll post on that in a...
  4. Replies
    4
    Views
    13,186

    Colin has been tremendously helpful, as usual. ...

    Colin has been tremendously helpful, as usual. Starting to look like one of the dividers in the Z-axis part of the controller has stopped working. Next few days are slammed, so will have to let...
  5. Replies
    9
    Views
    23,268

    Nevermind what I posted. Found the file in the...

    Nevermind what I posted. Found the file in the Makerfarm Upgrades folder. Sliced and it printed well.

    By the way, I punted on installing Slic3r 0.9.9 Linux version. The Github procedure...
  6. Replies
    4
    Views
    13,186

    *sigh* I meant to go to the Makerfarm forum with...

    *sigh* I meant to go to the Makerfarm forum with this. Oh, well. My guess is that this is a RAMPS controller issue and not really tied to Makerfarm, so *fingers crossed*.
  7. Replies
    4
    Views
    13,186

    Z-axis suddenly starting to move way too far

    Hello all,I'm definitely a noob and just finished my Pegasus 10 build. I did go for the Z-axis upgrades with the heated bed. The first test cube went well from the gcode file in the Makerfarm...
  8. Replies
    9
    Views
    23,268

    Slicer 1.2.9 on Pegasus, rather than 0.9.9

    Hi,After taking too much time in my build, I have a Pegasus 10. However, I'm having a little too much 'fun' trying to get Slic3r 0.9.9 to work on my system. How difficult was it for you to get...
Results 1 to 8 of 8