It could be that your 1st layer is a tad to close restricting the filament flow. This can build up on other layers to the point it can no longer push the filament out causing the clicking noise from...
Type: Posts; User: Make N Vape
It could be that your 1st layer is a tad to close restricting the filament flow. This can build up on other layers to the point it can no longer push the filament out causing the clicking noise from...
Cool, hope it helps. All the best.
Regarding Creality Slcier vs Cura probably not, cure has good Ender 3 / Pro profiles keep the layer speeds the same to start.
Things to change in cura
Temperature for heated bed 60c is a good...
Easiest way is to print a cube say 20mm high and measure with digital callipers.
You can also sometimes visually see a slight slip on a roller you end up going cross eyed after a while watching...
As food for thought, it might be time to change the PTFE tubing, and take apart the extruder gears and give them a clean out.
However also double check you Z height dimensions are correct, if the...
It's hard to say as the image is very small, but looking at the external walls, it could be under extruding.
As a newbie, I am presuming you have not yet heard or learned about calibrating the...