Close



Dig deeper, search our News website




Search:

Type: Posts; User: Not Sure

Search: Search took 0.00 seconds.

  1. I bought an Ender3 pro and it printed fine out of...

    I bought an Ender3 pro and it printed fine out of the box, just had to search youtube on how to properly install the x gantry because the directions tell you to do it the wrong way. I've spent...
  2. Replies
    3
    Views
    1,994

    Just bought a MEAN WELL RSP-500-24. I would...

    Just bought a MEAN WELL RSP-500-24. I would think I could just replace the 350w with this one. The stock bed draws 200w, and I'm gaining an extra 150w while using an extra 100w.
  3. Replies
    3
    Views
    1,994

    Upgrading Ender3 heated bed

    I just purchased one of those 24v silicon mats for my Ender3 pro. One thing I noticed is that it's 24v 300w, while some are 24v 200w. Am I ok to run it off the power supply directly, since most of...
  4. Replies
    1
    Views
    2,144

    BLTouch not finishing leveling

    Have BLTouch3.1 on an Ender3 pro with an skr mini 1.2 and newest marlin. Works fine if I manually level bed from the panel. If I run the G29 command however, it will only touch down on anywhere from...
  5. Replies
    1
    Views
    3,297

    BLTouch and extruder temp

    So I have my BLTouch 3.1 setup, works fine, running on my Ender3 pro using Cura slicer. If I run bed leveling from the menu, it works fine. My issue is running it from start Gcode in Cura. The...
  6. Replies
    11
    Views
    15,303

    Or just get the skr mini board. More memory and...

    Or just get the skr mini board. More memory and silent stepper drivers.
  7. Replies
    4
    Views
    2,619

    Take the case off for the mainboard and make sure...

    Take the case off for the mainboard and make sure the z cable is not loose
  8. Yes, i flashed it on my Ender3 pro. You will...

    Yes, i flashed it on my Ender3 pro. You will have to get Visual Studio code. I'm not sure if the memory size on the v2 board is larger than my pro, but you might want to upgrade to the skr mini...
  9. Replies
    2
    Views
    2,021

    Make sure connection is secure on the mainboard...

    Make sure connection is secure on the mainboard and fan. After that try reflashing the firmware. It should be running non stop when the printer is on.
  10. Replies
    7
    Views
    4,340

    So should I bother with linear rails on my...

    So should I bother with linear rails on my Ender3? How would I mount the side support rails ?
  11. Thread: Ender 3 fan

    by Not Sure
    Replies
    2
    Views
    2,178

    Ender 3 fan

    So did Creality screw up and reverse where the part fan and electronics fan plug in on the Ender3? Stock has the electronic fan in the FAN0 slot and part cooling in FAN1. If I set fan speed to 0 it...
Results 1 to 11 of 11