Search:

I have not printed anything in over 2 years. I have an early Creality CR-10 that been modified a bit. My last slicer was CURA 4.5. I rebuilt my computer and wiped the CURA installation and never put...

Hi, I'm looking for someone with knowledge of 12v electronics and LEDs to help with this project. I'm modeling this 5" Stargate SG-1 ring as a 2" auto hitch brake light. I'd like the center and the...

So I changed the heating element again. This time I put more solder on the joint. It is working now. I noticed that the last time the solder joints got hot enough to shrink the heat shrink. I'm...

Thanks for the response and info. I changed the heater again an made 2 prints. No problems. The last two times it failed on the third so we'll see on the next print. I believe my model is 12v. I'll...

I recently got a CR-10. After assembly, I did two test prints then the third failed. The hot end lost temp and dropped to room temperature. On a forum several people complained about the same...

Thanks for the reply. Did you really mean 30% or 3%? Or am I misunderstanding something? I've finished the model and exported the .stl. All check show watertight and no errors.

I just received my Creality CR-10. I’ll be using it to makesitems like the picture. (approx. 2.5”-1.5”) My questions regards tolerancesfor modeling. e.g. The nut for the clamp fits into the recess....

Thanks for the responses. I've been researching Cura and have cleared picture. Pet-g and ASA material sounds interesting. I'll do some more reading.

I'm new to 3d printing and have a CR-10 coming in a week. I have 3 noob questions.

1. What exactly is Cura, and is it necessary if you have software that generates .stl files? I have and am...