Close



Dig deeper, search our News website




Search:

Type: Posts; User: DragonXtreme

Search: Search took 0.00 seconds.

  1. Replies
    24
    Views
    27,886

    Well that is a totally different beast, :) enjoy...

    Well that is a totally different beast, :) enjoy the new ride.
  2. Replies
    24
    Views
    27,886

    I haven't tried glass or any other variations...

    I haven't tried glass or any other variations since I have not had an issue with the build plate. I did try the thicker raft settings yesterday. I am not real happy with that result as the raft tore...
  3. Replies
    24
    Views
    27,886

    Yeah it looks like you need to support the square...

    Yeah it looks like you need to support the square X, the rectangle X's look decent but they also look like they are also full depth. i would hold off on the temp change until you correct the support...
  4. Replies
    24
    Views
    27,886

    In one of the videos my rep sent me they talked...

    In one of the videos my rep sent me they talked about changing "raft base layer to 2.0" and "raft surface layers to 5.0" to make it easier and have a better bottom surface. I have not tried it yet as...
  5. Replies
    24
    Views
    27,886

    Jeff, Here is the baseline I am using. ...

    Jeff,

    Here is the baseline I am using.

    Create a new profile using Makerbot PLA for Z18 Standard.

    Setting I change in this created profile.

    Layer Height - I will modify this from 0.15 to...
  6. Replies
    24
    Views
    27,886

    Jeff, When I get back into the office tomorrow...

    Jeff,

    When I get back into the office tomorrow I will give you some settings I use. Yes I use the PLA from Makerbot as it is the only approved to run through the smart extruders.
  7. Replies
    24
    Views
    27,886

    I own a Z18 and initially between software and...

    I own a Z18 and initially between software and extruders I had a lot of issues to start. Since 3.4 and the 12.1 version extruders I have had very little problems getting out good prints. Most of my...
  8. Sorry, your original post says you were using 3.3

    Sorry, your original post says you were using 3.3
  9. 3.4.1 was released today with support for Windows...

    3.4.1 was released today with support for Windows 8.1, You might want to give that a try.
  10. From my perspective them releasing it when they...

    From my perspective them releasing it when they did was fine. The design is for it to be swap-able so revisions and improvements could be made throughout the printers life cycle. Do I like the fact...
  11. You said that you opened up the print head and...

    You said that you opened up the print head and saw major wear on it. Was just pointing out a source that had it in stock. It could be that the tension upgrade is not aligned correctly causing the...
  12. Is this what you are looking for? ...

    Is this what you are looking for?
    ...
  13. Replies
    7
    Views
    4,983

    I bought my Z18 through Dell for my business....

    I bought my Z18 through Dell for my business. Initially support was slow but over the last several weeks they have been very responsive and helping me with the issues I have been having with the Z18....
  14. 1st post on this forum, been reading a lot here...

    1st post on this forum, been reading a lot here and I just wanted to add some of my observations and a post that is still under moderation at MB Blog. I still haven't gotten what I consider a great ...
Results 1 to 14 of 14