Close



Dig deeper, search our News website




Search:

Type: Posts; User: OOL

Search: Search took 0.00 seconds.

  1. Replies
    21
    Views
    3,623

    How do you convert STL to Gcode.

    How do you convert STL to Gcode.
  2. Replies
    21
    Views
    3,623

    Question on PLA or ABS for ET4 printer. What is...

    Question on PLA or ABS for ET4 printer. What is the best to use PLA or ABS. Any brands recommended or to stay away from?
  3. Replies
    21
    Views
    3,623

    Success! We got it working & printed fine.Thanks...

    Success! We got it working & printed fine.Thanks again for your help on the forum, the bed leveling & print head was the issue. OOL.
  4. Replies
    21
    Views
    3,623

    Hi Thank you, that gives me quite a bit to go on....

    Hi Thank you, that gives me quite a bit to go on. Its the ET4 model, I also adjusted the sensor on the print head as it was hitting the print plate. Should I try adjusting that a little at the...
  5. Replies
    21
    Views
    3,623

    Hi Thanks for the reply, Yes that's correct. Its...

    Hi Thanks for the reply, Yes that's correct. Its self leveling but I will try to lower it. Is there a way to stop the print head from moving while I adjust it? Should the base plate by luke warm ,...
  6. Replies
    21
    Views
    3,623

    New - can't get started.

    Hi can someone help please, I am new to 3D printing & to this forum. The printer is set up but not sticking to the base so failing at the starting point. Its a Labists. OOL
Results 1 to 6 of 6