Search:

Here are some screenshots from the Slicer setup also.

14502 14503 14504 14505

Thanks for having offering to look through them. Be great if I can get this printer working at its best.

I've included some screenshots of the Slicer settings. Imagine these settings can be different for different printers, but chances are you might notice something that is to low or high.
14499 14500...

Including a picture of the Bukito. It's a relatively small 3d-printer. Uses a filament spool on a turn-table.
Extruder is Bowden setup using hobbed bolt as the filament drive gear.
Synchromesh...

Thanks for the reply Roberts_Clif

You were right! It was under-extruding by a lot.
Took me a bit to figure it out. First I thought the nozzle needed cleaning, since a few prints just stopped...

Hi everyone.

Hoping someone can help get me somewhere better on these prints.

Have a Bukito, running Repetier-Host. Slicing using Cura.
Layer height: 0.2
Nozzle diameter: 0.4
Nozzle temp:...