Search:

Actually the main reason I upgraded the board was to quiet down the printer. It made a huge difference in that respect. I misspoke on the PETG part.

I'm pulling my hair out now. This problem has a mind of it's own and I can't pin it down to anything specific. I have swapped cables, motors and stepper drivers and it seems to work for a bit with...

Yeah, I'm going to order a new cable and start from there. Thanks.

I have the hot end heated up while I'm troubleshooting it.

It's not that. I have it removed from the mount and the gear is off. Doesn't run when requested to.

I have a problem with my extruder and don't know where to turn. It has been sporadically stopping extruding partway through a print for a couple weeks. If I restarted the printer it would behave fine...