Close



Dig deeper, search our News website




Search:

Type: Posts; User: ole_blue_moon

Search: Search took 0.00 seconds.

  1. Replies
    6
    Views
    4,358

    Hello, None of the issues were related to the...

    Hello,

    None of the issues were related to the 3 different printers I've had over the last 4 years. All the issues were related to the process of FDM/FFF. If all you're printing is smallish objects...
  2. Replies
    6
    Views
    4,358

    Hello, Sounds like you have quite a project to...

    Hello,

    Sounds like you have quite a project to decide what to do. Previous post had a lot of good info. There is a learning curve associated the low to mid level FFF printers. They have to be...
  3. Replies
    4
    Views
    3,482

    Hello, I suspect part of your problem is...

    Hello,

    I suspect part of your problem is moisture getting into the filament. All the plastics absorb water and become brittle and start to print poorly. E.g., I was printing from a roll of pla for...
  4. Replies
    6
    Views
    5,854

    I don't see what advantage they have over other...

    I don't see what advantage they have over other hot ends other than larger diameter nozzles. The example they show of the object with the quarter on top looks pretty rough, for most of my uses I...
  5. Replies
    12
    Views
    30,321

    This is one technique that works pretty well for...

    This is one technique that works pretty well for removing from Kapton tape. Take a utility knife, the large type with the sliding blade that breaks off in sections. Side the blade out as far as it...
  6. Replies
    1
    Views
    2,801

    I almost always use a raft usually 3 layers,...

    I almost always use a raft usually 3 layers, except in one case. Using a raft helps compensate for a bed that is not perfectly level, the first layer of the raft will be of varying thickness due to...
  7. Flashforge Dreamer procedure to adjust nozzle heights

    Hey guys, in my experience In order to print using 2extruders it is imperative that both nozzles be as close as possible to thesame height above the bed.

    Here is one way to get the 2 nozzles...
  8. Replies
    6
    Views
    7,570

    One thing I have found about the Dreamer...

    One thing I have found about the Dreamer extruder, running an unload routine after an idle period can cause a jam at the driver gear. After disassembly looks like the filament gets a small ring or...
  9. Replies
    13
    Views
    12,742

    I have had the same problem with oozing or...

    I have had the same problem with oozing or dripping from the idle extruder, mostly the one with PLA in a 2 extruder setup. My first preference was to use PLA for raft and support, and ABS for object....
Results 1 to 9 of 9