I so miss working at Rocketdyne.. good times.
Type: Posts; User: beerdart
I so miss working at Rocketdyne.. good times.
Does the hob bolt turn freely? Also check the hob bolt teeth for wear and flat spots.
The wave washer has .022" or .55mm movement and bottom's out each push. X/Y is pretty rock solid. The nozzle is generic and works well ( broke the originals when I was drilling them to 3mm as at the...
Pics as I was cleaning up the hot ends.
...
Here is our RC6bugfix. MakerFarm i38" RAMPS 1.4 Itty Bitty dual flex E3D 3mm servo ABL.
The hollow bolt was v1 the vid is v2. Its a E3D hotend with the top groove machined off and a new top hat attached with a hollow flat head screw. The mounting plate was thickened and a tight...
Like this?
http://vid113.photobucket.com/albums/n204/beerdart/Mobile%20Uploads/20151212_180159_zps4kbwfn1m.mp4
http://www.metric-conversions.org/length/microns-to-millimeters.htm
Thanks Ill look into it..
Under machine settings check flip build table axis Y. Most printers use right front as home the MF uses back right.
Im using RC3 without any issues. Perhaps it is a bug.
How about the Z probe offset?
Sounds like your offsets are screwy
My experience with eSun has been well it sucks. Ive tried it a few times both ABS and PETG the last one was recent with there PETG and we were slipping grinding and just plane printing like crap the...
:cool:........................
Try adding retraction. PETG is stringy stuff.
I dont see the need to make the hole in the extruder 1.75 the 3mm hole should have no problem with 1.75 as long as your extruder is setup for 1.75.
Good deal its been a while since ive used pronterface.
And yes the firmware will prevent cold extrusion.
Is the driver installed with the correct orientation?
Pink shirt.. working at Rocketdyne No 3D parts..
Loved working on the Atlas program.
9090
Its my own design loosely based off. http://www.dglass3d.com/hotends/
Mine uses E3DV6 and extended groove mount and brass bushing.
Normal retraction works fine.
http://vid113.photobucket.com/albums/n204/beerdart/Mobile%20Uploads/20151212_180159_zps4kbwfn1m.mp4