Search:

Thank you for checking that, I finally found the problem, it seems both the bed and hotend thermistors somehow burnt out. I ended up connecting a varible resistor in place of the thermisor and...

Ah sorry, I forgot to mention this is indeed in degrees Celsius. So not room temperature. And could be. Like I mentioned I might have damaged the hotend thermistor by accident, but I haven't touched...

Okay yes. So I measured the resistance of the thermistor. Its about 50k ohms at room temperature. But no matter what I do the temp is still displayed at 111 for the hotend and 108 for the bed. Even...

You were right!! I tried another config program and managed to find my LCD specifically! The LCD is working now, thank you two for your help! Unfortunately I still have one more problem, the...

Thank you, I'll try that one. Unfortunately I don't have enough posts to send links yet.

Haha yes, lesson learnt. And I'm not sure if there is a different way. But what I did was go into the configuration.h to the LCD controller section and enable the display most similar to mine. I have...

Hello,

I am new to 3d printing, and recently purchased a Tevo Flash. Everything was fine till after several weeks of use I tried to update the firmware. After flashing though, the LCD (while...