Close



Dig deeper, search our News website




Search:

Type: Posts; User: Zuru1

Search: Search took 0.00 seconds.

  1. Replies
    4
    Views
    5,732

    Ok, i did surspect that will initially start out...

    Ok, i did surspect that will initially start out with a 50x50x50 cm cube. That should accommodate for a 300x300 or 240x340mm bed. Time to hit the cad and see were i end up at.
  2. Replies
    4
    Views
    5,732

    Thanks for sharing. The ones I have found are...

    Thanks for sharing.

    The ones I have found are 2 mm thick, which is fine after testing to bend them.
    Now I have to figure out the length I need for my build.

    How does one calculate the cube...
  3. Replies
    4
    Views
    5,732

    Use square aluminium tubes for corexy printer?

    Hi,

    I'm currently building and designing a corexy 3D printer and was wonder if I could use square aluminium tubes for the frame.
    I know that one can use V-slot rails, but those are not locally...
  4. Replies
    7
    Views
    10,773

    Well I replaced the glass and got a flat bed and...

    Well I replaced the glass and got a flat bed and recalibrated the hole printer twice just to make sure and still no change.
    I also tried RC7 firmware version to see if that would solve anything,...
  5. Replies
    7
    Views
    10,773

    So I changed to the RCBugFix version and disabled...

    So I changed to the RCBugFix version and disabled min_software_endstops and was able to calculate z probe offset.
    Same behavior as before when printing the calibration print no matter how close the...
  6. Replies
    7
    Views
    10,773

    They are both set to true in both versions. If...

    They are both set to true in both versions.

    If I disable them (set them to false), won't that be totally removing any safety measures for travel over the a given axis length?

    Does it matter if...
  7. Replies
    7
    Views
    10,773

    Update: Tried the Marlin RCBugFix version and...

    Update:

    Tried the Marlin RCBugFix version and the same problem that I had before still prohibits me from lowering the nozzle so that I can calculate the z-probe offset.
    Even if I change the Z min...
  8. Replies
    7
    Views
    10,773

    Hi, I'm on Marlin version 1.0.2-2. ...

    Hi,

    I'm on Marlin version 1.0.2-2.



    Front-left point
    >>> m48 v4
    SENDING:M48 V4
    M48 Z-Probe Repeatability test. Version 2.00
  9. Replies
    7
    Views
    10,773

    Auto bed leveling G29 data ignored during print

    Hi

    I decided to add auto bed leveling/trimming on my printer using a PNP inductive proximity sensor switch (LJ12A3-4-Z/BY).
    At the moment I have managed to get the initial set up, were to probe,...
  10. Anyone? I have been at it for a while and...

    Anyone?

    I have been at it for a while and would like to fix this so that I can go on with using my printer.
  11. Prusa i3 Rework auto bed leveling/trimming G29 data not used

    Hi

    I decided to add auto bed leveling/trimming on my printer using a PNP inductive proximity sensor switch (LJ12A3-4-Z/BY).
    At the moment I have managed to get the initial set up, were to probe,...
Results 1 to 11 of 11