Close



Dig deeper, search our News website




Search:

Type: Posts; User: logic

Search: Search took 0.00 seconds.

  1. Replies
    3
    Views
    1,666

    After some further investigation, it looks like...

    After some further investigation, it looks like this might be a linear ball bearing wrapped in a bit of plastic, and I might be able to make do with a couple of worm gear clamps around the plastic to...
  2. Replies
    3
    Views
    1,666

    After much Googling, I haven't found much but I...

    After much Googling, I haven't found much but I did find this:

    https://www.ebay.com/itm/1x-LMH6LUU-Metric-8-5mm-Inner-Dia-Oval-Flanged-Long-Linear-Bearing-/264508028984

    The guide rods do seem...
  3. Replies
    3
    Views
    1,666

    TRONXY X5ST-400 -- what is this broken part called?

    Sigh.

    My printer was built from a kit (TRONXY X5ST-400), and I can't find a parts list anywhere. I managed to break something important, but I don't know what it's called in order to search for &...
  4. A 300x300 silicon pad stuck to the bottom of the...

    A 300x300 silicon pad stuck to the bottom of the 400x400 aluminum print bed (which has an integrated 12/24VDC heating circuit that I'm not using) seems to be working quite well. The heat takes a...
  5. Thanks for your reply :-) I'll proceed then with...

    Thanks for your reply :-) I'll proceed then with a 300x300 heater on the 400x400 aluminum plate, and I'll give an update once I know how it's going. :-)
  6. Can a bed heater be smaller than the bed and still give good results?

    I have a TRONXY X5ST-400 that I built from a kit. When I first powered it on, the control board immediately exploded, so I have been working on reworking it to use an SKR 1.3. Unfortunately, it...
Results 1 to 6 of 6